Search found 5 matches
- 21:08, 6 February 2019
- Forum: RD-700 / 800 series
- Topic: Power Switch on Roland RD800
- Replies: 3
- Views: 3903
Re: Power Switch on Roland RD800
Well, I've fixed the problem - I think. I had some velcro ( both sides ) left over from building my pedalboard a while back and I stuck two pieces of velcro on to the back of the RD800 on either side of the on/off switch. Then I applied the opposing velcro to two small pieces of rubber that were sli...
- 22:11, 2 February 2019
- Forum: RD-700 / 800 series
- Topic: Power Switch on Roland RD800
- Replies: 3
- Views: 3903
Re: Power Switch on Roland RD800
Not true. The DC cable was on a different side than the on/off switch. It was certainly put there to protect the switch. Unless you're talking about a different plastic piece.
- 17:00, 29 January 2019
- Forum: RD-700 / 800 series
- Topic: Power Switch on Roland RD800
- Replies: 3
- Views: 3903
Power Switch on Roland RD800
I used to own a Yamaha CP33. On the back, right beside the on off switch was a little piece of plastic, screwed in to the back - the purpose - I'm guessing - is if you put the keyboard down on the back surface the keyboard would lie on the plastic bit and prevent damage to the on/off switch. The RD8...
- 00:50, 8 January 2019
- Forum: RD-700 / 800 series
- Topic: Change Live sets via MIDI remotely help?
- Replies: 10
- Views: 10191
Re: Change Live sets via MIDI remotely help?
I have my settings set exactly as you have stated above. My DAW is Reaper, I still cannot get this to work. I’m starting to think this is not possible on the RD800.
- 16:53, 29 December 2018
- Forum: RD-700 / 800 series
- Topic: RD800 - sending program changes from Reaper
- Replies: 1
- Views: 3101
RD800 - sending program changes from Reaper
I'm trying to get Reaper ( my DAW ) to send program changes to the RD800 to change live sets. So far unable to do so. I have my program changes going out on channel 1 and my input receive channel on the RD800 also set to one. I'm using the msb/lsb/program values from the values in the manual for the...