Copying/editing sequencer tracks- silly question!

Forum for JUNO-G
Post Reply
jimdunlop
Posts: 12
Joined: 22:02, 7 July 2011

Copying/editing sequencer tracks- silly question!

Post by jimdunlop »

Hello again-
I'm getting a blank measure after I've copied for example all measures 1 to 5 for say 10 times.
I'll end up with one empty empty measure at measure 9, and so on.

Am I doing something stupid??

Also, is there any way to "solo" play to isolate or listen to an individual track when in micro edit mode?

Thanks in advance.
dennis elbow
Posts: 70
Joined: 17:57, 1 February 2014

Re: Copying/editing sequencer tracks- silly question!

Post by dennis elbow »

that's the problem straight away you are copying the 5th measure which is empty or you may have accidently recoded data into the 5th measure.delete the 5th measure only, then try again to copy from 1 to 4 measure and place that either at the end/destination, for all which means all the other tracks 1/16 or just the track you are in.it is a little confusing but stick with it and you will go blimey that was easy.
dennis elbow
Posts: 70
Joined: 17:57, 1 February 2014

Re: Copying/editing sequencer tracks- silly question!

Post by dennis elbow »

you can mute the other tracks then go into micro edit.
Post Reply