Page 1 of 1

Can Juno-G transmit control changes?

Posted: 02:23, 20 December 2016
by Tarkov72
I'm using the Juno-G as a controller for a desktop synth and I need to make some control changes to CC90. Can the Juno-G do this? I can't figure it out from reading the manual. Granted, I know very little about midi so any help would be great! Thank you!

Re: Can Juno-G transmit control changes?

Posted: 00:49, 23 January 2017
by Blues4dog
It will transmit cutoff (cc74) and res (cc71) in perform mode on the selected sequencer channel. You could assign cc90 to either the d beam or a control pedal. Another option would be midi mapping or midi learn within your software or a program to convert cc messages. If you want to control soft synth parameters I would suggest a cheap USB controller like the Korg nanokontrol.