Sound level problems on MC 303?!

Forum for MC, SP, TR series and other groove and drum machines
Post Reply
gj1982
Posts: 1
Joined: 02:16, 25 March 2011

Sound level problems on MC 303?!

Post by gj1982 »

Hi there
I'm a total newbie to the MC303, having recently acquired it. I'm slowly getting to grips with some aspects of it. However, a big problem I'm having is that while the drums/patterns play fine at normal volume levels, when I try to ply the keyboard keys to use a synth sound or arpeggiator, the sound coming out is very minimal, just audible but too low to use.

I have gone through the manual but can't seem to find a remedy, was just wondering if anyone could help? Thanks!
Robert13
Posts: 11
Joined: 13:09, 25 May 2010
Location: Netherlands
Contact:

Re: Sound level problems on MC 303?!

Post by Robert13 »

Hello,

I had the same problem. A factory reset will do the trick, but al memory will be cleared!! Factory reset is holding down the SHIFT-key an power-on the MC-303. I had another problem. The PCB was broken, so I had to solder some wires.

Robert
Post Reply