Hi there,
I cannot seem to find a way to edit the (vertical) bender parameters. I have searched the web and the manual and cannot seem to find the answer. Editing the parameters for left and right is clear.
Thank you.
V-Synth GT Bender Help
Re: V-Synth GT Bender Help
Hi. The vertical bender is the Modulation so is linked to CC01. This parameter is usually pre-wired in the Matrix Control, control 5. At least in the standard V-Synth it is. You should see that the source is CC01 and the destination is Osc 1/2 LFO PCH.