Ok I must be missing something here. All I want to do is make it so that my lower half of my keyboard plays no arpeggio while my top half does play arpeggio. Ive read the manual and it says that when in dual split mode, when the upper button is blinking, all the buttons you push should ONLY effect the upper section and vise versa. So heres what I do
Dual split mode
push upper button and apply arrpeggio
but when I go back to lower the arpeggio is applied there too so I try push the arpeggio button in lower mode, in hopes that it will JUST be disabled in lower mode, but then when i go back to upper its disabled as well...what am I doing wrong?
Roland SH-201 arpeggio split
-
- Posts: 8
- Joined: 09:36, 9 November 2009
- Location: Oregpn
- Contact:
Re: Roland SH-201 arpeggio split
You can only disable it in the editor, set it on upper, disable it on lower part.
-
- Posts: 8
- Joined: 09:36, 9 November 2009
- Location: Oregpn
- Contact:
Re: Roland SH-201 arpeggio split
ahh well. thankyou that anwsers my question. unfortunately Im running vista 64 bit...no drivers for me. bummer. thanks though
Re: Roland SH-201 arpeggio split
np mate
You can try out Sun xVM VirtualBox (it's free) and setup a 32bit XP on a 5GBs virtual drive (easy to make into VB)
Setup the driver and the editor/librarian and thats all.
You can save this virtual partition and reload when You need it.
Have a nice day,
Attila
You can try out Sun xVM VirtualBox (it's free) and setup a 32bit XP on a 5GBs virtual drive (easy to make into VB)
Setup the driver and the editor/librarian and thats all.
You can save this virtual partition and reload when You need it.
Have a nice day,
Attila
-
- Posts: 8
- Joined: 09:36, 9 November 2009
- Location: Oregpn
- Contact:
Re: Roland SH-201 arpeggio split
ah thankyou very much! installing it as we speak