Just looking for some advice on the System Midi Settings.
My cursor/value dial started to act up and motivated me to start learning how to use my midi controller (Edirol PCR-800) to control my Soniccell during performances. Most important, I want to be able to change performances using Program Change and the value knob on the PCR.
It worked straight out-of-the-box, but I noticed that if I moved certain other controls on the PCR, that the Soniccell would stop responding to Program Change messages. In my ignorance, I reboot the Soniccell when this happens (bummer while on stage).
I found that after turning all the System Midi settings off, except RX Program Change, that this does not happen. Turned off: Bank Select, Exclusive, GM System, GM2 System and GS Reset.
Is this ok? Will this impact using Soniccell editor, librarian, Logic 8?
If it is important, I have the PCR set to use factory control map 14 (GM), don't really adjust sounds much during performance, but would be nice to use at some point.
Thanks.
Also, Ordered a new cursor/value control from Roland for $20, but they said it needs to be ordered from Japan and may take 4-6 weeks to receive.
Soniccell System Midi Settings
-
- Posts: 3
- Joined: 03:13, 13 April 2010
- Location: Dallas
-
- Posts: 3
- Joined: 03:13, 13 April 2010
- Location: Dallas
Re: Soniccell System Midi Settings
Forgot one detail, I set Perform Ctrl Ch to 1 (was 16).