can you split patches by velocity in performance mode ?

Forum for SonicCell
Post Reply
zzzxtreme
Posts: 29
Joined: 02:20, 20 July 2009

can you split patches by velocity in performance mode ?

Post by zzzxtreme »

hi guys, I've tried to read the online manual, it does mention key range split in performance mode, but not velocity split. is it possible to split patches by velocity in performance mode ?
User avatar
piaknowguy
Posts: 2071
Joined: 22:29, 14 April 2004
Location: Canada
Contact:

Re: can you split patches by velocity in performance mode ?

Post by piaknowguy »

Yes, but you would have to modify the velocity range of each of the patches you intended on using and save them to USER memory. Then set up your Performance with the modified patches.
zzzxtreme
Posts: 29
Joined: 02:20, 20 July 2009

Re: can you split patches by velocity in performance mode ?

Post by zzzxtreme »

thanks for the reply. has it always been that case since XP series ? That's kinda .... lame :(
rcraven
Posts: 629
Joined: 14:36, 9 September 2007
Location: Melbourne Australia

Re: can you split patches by velocity in performance mode ?

Post by rcraven »

The Performance allows you to edit the velocity range of the Tones in the Parts with out altering the patches

On the Editor go to the Performance section
Third from the bottom is Velocity & Key Range
You can edit the Velocity range for each of the Tones (4) for each Part (16 Click just below the name to change the part you are editing)


Royce
Post Reply