The Oh Sherrie sound.

Forum for Fantom-S/S88, Fantom-X6/7/8, Fantom-XR and Fantom-Xa

The Oh Sherrie sound.

Postby Robertdsmn » 20:42, 10 September 2017

Hi. I found a patch on my Fantom X7 that pretty much nails the synth sound used on Steve Perry's tune Oh Sherrie. It is called Vint Clavier and it is on bank H #064. The only problem I have with it is that I want to use it for a different song, but I can't get rid of the phase shifter type effect that is on it. I tried turning the effects off but that doesn't work. Any ideas of how to take that effect off ?
Thanks.
Robertdsmn
 
Posts: 3
Joined: 01:12, 11 August 2017


Re: The Oh Sherrie sound.

Postby gdh » 14:42, 11 September 2017

I have a VintageClav in PR-I 013 in Keyboards area that I imagine is the same. It shows Tone 1 MFX @127, MFX-1 11 Phaser - 127A @ 80. If you turn to Thru which is 0 you get rid of the Phaser, or insert whatever fx you want to replace the Phaser. I usually setup these as Performance patches, zero out the fx and add what I want then write lvg the original patch intact.
gdh
 
Posts: 19
Joined: 13:53, 19 June 2017
Location: Canada

Re: The Oh Sherrie sound.

Postby Robertdsmn » 17:40, 11 September 2017

Great. I'll try it. Thanks.
Robertdsmn
 
Posts: 3
Joined: 01:12, 11 August 2017

Re: The Oh Sherrie sound.

Postby Robertdsmn » 02:20, 12 September 2017

Oh well. That didn't work.
Robertdsmn
 
Posts: 3
Joined: 01:12, 11 August 2017

Re: The Oh Sherrie sound.

Postby gdh » 21:33, 12 September 2017

So if you change from Phaser to a rotary for eg the phaser is still on? Have you turned tone 1 off, turned MFX-1 to 0 from 127? I am not at my X6 right now so just going from memory. I'll take a look and also go through Patch edit to look at the patch's structure but I had no problem turning Phaser off in either Patch or Performance mode using above. Are you listening with headphones plugged into the keyboard?
gdh
 
Posts: 19
Joined: 13:53, 19 June 2017
Location: Canada

Re: The Oh Sherrie sound.

Postby gdh » 23:28, 12 September 2017

Just pulled up Phase Clav in the Keyboards area, was able to turn Phaser off when push effects button and hit effect sw (f8) then hit f1 to turn MFX1 off. Don't forget about the patch edit area, thats where you can gain full control over your sound and modify it to your hearts desire.
gdh
 
Posts: 19
Joined: 13:53, 19 June 2017
Location: Canada


Return to Fantom-S and Fantom-X

Who is online

Users browsing this forum: No registered users and 2 guests