Hi all,
I'm trying to work out a way to set up the Control Pedal to morph between two sounds.
I've got a Patch programmed where Tones 1 & 2 make up sound A and tones 3 & 4 make up sound B.
On the Alesis QSR I would set the control pedal to control Volume cc07 (or Expression cc11) and set Tones 1&2 to 0, modulating to 127, and then 3&4 to 127 modulating to 0.
I'm sure it's as straight forward on the Fantom, but I can't work it out.
Has anyone done this already? Any help gratefully received!
Cheers,
Andy
Control Pedal to Morph between Two Sounds
- piaknowguy
- Posts: 2071
- Joined: 22:29, 14 April 2004
- Location: Canada
- Contact:
Re: Control Pedal to Morph between Two Sounds
Hey Andy!
I"m not near the board right now but I have done this between 2 patches before.
I would copy tones 1 and 2 to 1 USER patch and tones 3 and 4 to a second USER patch and go from there.
Cheers!
I"m not near the board right now but I have done this between 2 patches before.
I would copy tones 1 and 2 to 1 USER patch and tones 3 and 4 to a second USER patch and go from there.
Cheers!
Re: Control Pedal to Morph between Two Sounds
Hi Andy,
Adding to piaknowguy, go to the Matrix Control and set an input to an unused CC.
Destination is LEVEL, Tone 1&2 are ON and Tone 3&4 are REV and adjust SENS to full (or -ve full if it xfades the wrong way).
Menu button - Pedal/DBeam set the Continuous Pedal to the above CC.
All the best
Royce
Adding to piaknowguy, go to the Matrix Control and set an input to an unused CC.
Destination is LEVEL, Tone 1&2 are ON and Tone 3&4 are REV and adjust SENS to full (or -ve full if it xfades the wrong way).
Menu button - Pedal/DBeam set the Continuous Pedal to the above CC.
All the best
Royce