problem with Juno Stage.?

[DaveC]

when i turn unit OFF ... it will not remember the Key Velocity Sensitivity that i had saved ... in the general Menu section ..

yes ,.. and am hitting the Write button after the change is made ...

as soon as i change the value by 1 ... then the Key Velocity Sensitivity comes on correctly and works correctly until unit is powered OFF .... then it Resets itself back to 0 ..!!??

i have to reset it evry time i turn it ON ... that's not quite right ..?!!?

thanks for any suggestions ... maybe a software update .!??
Dave C.

[acim]

Mine memorizes all changes in velocity after shutdown...

[DaveC]

mine remembers Velocity for seperate programs also ..

but in the main Menu , were you set the over all Velocity ..

Light/Medium/Hard ... it remembers that ...

but right below the is the Vel Sensitivity ...

i have mine set at 40 ... it remembers and shows that number ... but it does not respond like it's set at 40 , it responds like it's back at zero ... as soon as i change that setting , it then acts as it should ..??

thanks .!

[acim]

I tried this vel sensitivity thing with some values and yes, it is NOT memorized. The value that I stored is remembered but the result is a reset to zero... You are right... So, a fix for a coming update should it be indeed!

[DaveC]

thank you very much for trying that out ..!!

i emailed Roland about it ... and my saleman ...


glad i'm not just missing a step somewhere ... !

DC