Page 1 of 1

Sustain problem with Juno Stage

Posted: 09:06, 17 January 2017
by Ramzesdidi
I bought my first Juno Stage yesterday and found a problem. I have two sustain pedals with different polarities, so I tried both of them (insert into Hold, right?). After I disconnected the pedals, the keyboard continued to sustain for a while. Sometimes it stopped and then it was beginning to sustain again (with pedals disconnected).

Is this some kind of a short reaction of the keyboard to the pedals with different polarities or is this a more serious problem?

Thank you

Re: Sustain problem with Juno Stage

Posted: 01:41, 26 January 2017
by QmusicRAZZ
It is probably a quirk in the Juno Stage. That board had some weird issues throughout it's run. There is probably steps you can take to make it the same every time.

Re: Sustain problem with Juno Stage

Posted: 04:14, 2 May 2017
by flyingace
I had that issue, I fixed it by doing one of the following (I actually did all three but don't know which one actually fixed it, just glad it did!):
Turn off continuous switch on pedal (if equipped)
Restore Juno to factory, then restored my backup
Used a Roland brand pedal

Works ever since. Good luck!