MIDI DEvice Error
MIDI DEvice Error
When I run the Juno DI editor, I get an error message that says "MIDI devices aren't set up correctly". When I look for the Juno in set up, no other devices appear. I have the keyboard connected to the computer with a Belkin USB 2.0 Printer Cable. Is that the correct cable to use? If not, what will work? Thanks.
Re: MIDI DEvice Error
The cable should work, if it is not damage. Did you start the editor AFTER plugging in the cable? Try other usb ports from your PC.
Re: MIDI DEvice Error
Okay, thanks. I will try that.
Re: MIDI DEvice Error
Okay, I tried that and I still have the same problem. When I plug the USB cable in the computer gives me a message " Found new hardware." Then a window comes up to telling me to insert the CD to install the software, but I have already installed it, so I hit cancel. Then I get a pop up message that says " Found new hardware. A problem occurred during hardware installation. Your new hardware might not work properly." The computer does not seem to recognize the keyboard when I look at the drives with Windows Explorer.
Re: MIDI DEvice Error
Hi,
try these steps in this sequence
1. Disconnect the cable
2. Remove the driver
3. Reinstall the driver
4. connect the cable
HTH
Frank
try these steps in this sequence
1. Disconnect the cable
2. Remove the driver
3. Reinstall the driver
4. connect the cable
HTH
Frank
Re: MIDI DEvice Error
Frank,
Thanks, that worked.
Thanks, that worked.