Page 1 of 1

Kawai K3 Editor using MIDI Touch

Posted: 06:19, 21 March 2011
by Computer Controlled
I'm almost done with this but im running into an issue:

There are a few parameters that require a negative value. OSC Balance for one. It goes from -15 to 15. I can't figure out how to get around this. The controller i have set up for this only controls it from 0 to 15. In other words, Both Osc 1 & 2 in the mix then to just Osc 2. I can't get it to go down to -15 (just osc 1 in the mix).

The VCF kbd tracking is the same way. -15 to 15. But this time, the controller goes from -15 to 0. This is all so confusing!