"Autopan" without using effects

Forum for JUNO-Gi
Post Reply
uraeus
Posts: 2
Joined: 11:29, 1 February 2015

"Autopan" without using effects

Post by uraeus »

Hi guys,
on the Juno-Gi it seems to be possible to apply an "Autopan" to a sound without using an effect. I hope the term I´m using is correct- you can hear the sound moving from one side to another.
Here an example (which unfortunately only makes sense if I´m referring to an original factory sound of the Gi, which I hope I´m doing):
In the special live set there is sound no 39 called "Synthology": Here Tone 391 Analog Seq in the upper layer has an Autopan which is not created by the effect section as far as I could figure it out. So my question is: How is it done?
Best regards and thank you for taking your time
Frank
joe001
Posts: 1
Joined: 19:54, 3 February 2015

Re: "Autopan" without using effects

Post by joe001 »

Hi Frank!
It's the pro editor / LFO1. It works with any sound without MFX.
User avatar
CesarsoundOne
Posts: 203
Joined: 21:29, 9 October 2014

Re: "Autopan" without using effects

Post by CesarsoundOne »

Route the LFO to the PAN of wave.
uraeus
Posts: 2
Joined: 11:29, 1 February 2015

Re: "Autopan" without using effects

Post by uraeus »

Thank you so much- I knew there must have been something I´ve been missing on. Thank you for taking your time.
Post Reply