I feel really stupid that I can't figure this small problem out myself.
I created a solo violin patch where I wanted a fast portamento between pressed notes.
My problem is that I seem to only have the portamento going from a high note to a low note but can't get the portamento to apply from low note to high note?
How do you program portamento to go both directions?
Help on portamento question
Re: Help on portamento question
Sounds like you have the solo layer in monophonic mode.
Press edit next to the registration name, then press the solo tab. At the bottom on the left options is mono/poly. Select poly. Then see if that works. :)
Press edit next to the registration name, then press the solo tab. At the bottom on the left options is mono/poly. Select poly. Then see if that works. :)
- richardbates1
- Posts: 389
- Joined: 19:58, 19 July 2013
Re: Help on portamento question
Thanks Cello, I was going about it all wrong.cello wrote:Sounds like you have the solo layer in monophonic mode.
Press edit next to the registration name, then press the solo tab. At the bottom on the left options is mono/poly. Select poly. Then see if that works. :)
I was trying to create a solo violin in the upper registration instead of solo.
Then when I changed portamento from TONE to ON and adjusted the timing on the portamento it worked the way i was wanting it to.