Page 1 of 1

Pitch bend the whole registration

PostPosted: 05:40, 6 March 2017
by chbrze
I'm new to synths in general and just bought the Jupiter 80 to use in my band. I can't figure out how to make the whole registration do a 1 octave pitch bend with the D-beam controller. I see how to make either the percussion or solo part do it but not all the sounds in the registration together. Can anyone tell me how to do this? Thank you for any help.

Re: Pitch bend the whole registration

PostPosted: 11:43, 13 March 2017
by kimsnarf
Enter Registration edit/settings, choose Common/Control, choose the Control SW tab and you see a matrix of controllers (pitch bend, D-Beam etc) which you can turn on/off for solo/upper/lower/perc.