Juno 106 Display - - Not Responding
Posted: 18:47, 6 February 2015
My Juno 106 display reads - - and does not respond to any button pushes. Booting with Key Transpose does not put it into test mode. The manual part of the synth seems to work fine, cutoff, resonance, noise, etc. I don't think there are any dead voice chips, it seems to respond ok. Could this be something as simple as a dead battery, or is this a low voltage condition. I opened up the front guard panel and found a green wire jury rigged to it - duct tape (ground?). I have seen all kinds of information about checking for dead voice chips and also how to get it into test mode but I have never seen any information about when it just boots to - - and won't respond. Any one have any ideas?