Guys, I have Roland M265E card memory and I wanna change battery but don't have instructions and I don't wnt to tear apart card.
Does anybody knows how you change it or maybe where I can see manual?
Also, where can I use this card....U-20, D-50, or???????
Roland memory card M256E
Re: Roland memory card M256E
Hey Gorky,
No worries, you don't have to tear apart your card. If you look just above the Roland logo on the top front of the card you should see a small indentation in the plastic trim. That's actually the battery compartment and if you slide your fingernail in and pull straight up it should pop out. Just replace it with a fresh CR2016 battery, positive-side up and slide it back in.
The card is apparently compatible with several units, but mine resides in the back of an old U-20.
Here's a pic if my explanation doesn't make sense. It's an M-128, but it's the same design as yours.
http://www.deepsonic.ch/deep/pix/roland_m-128d_1.jpg
No worries, you don't have to tear apart your card. If you look just above the Roland logo on the top front of the card you should see a small indentation in the plastic trim. That's actually the battery compartment and if you slide your fingernail in and pull straight up it should pop out. Just replace it with a fresh CR2016 battery, positive-side up and slide it back in.
The card is apparently compatible with several units, but mine resides in the back of an old U-20.
Here's a pic if my explanation doesn't make sense. It's an M-128, but it's the same design as yours.
http://www.deepsonic.ch/deep/pix/roland_m-128d_1.jpg
Re: Roland memory card M256E
Hello gorky,gorky wrote:Guys, I have Roland M265E card memory and I wanna change battery but don't have instructions and I don't wnt to tear apart card.
Does anybody knows how you change it or maybe where I can see manual?
Also, where can I use this card....U-20, D-50, or???????
I'm not aware of any instructions per se.
There is a small plastic carrier which holds a cr2016 coin cell battery in the end opposite the connection point.
Carefully pull that straight out with a fingernail. Cheers, hanon
Re: Roland memory card M256E
Tip: If you replace the battery while the card is inserted in the slot of a powered-up synth (for which it is formatted), it won't lose its stored information.