JD-800 Factory Patches

Forum for JD, JV, XP and XV synthesizers from 1990's

JD-800 Factory Patches

Postby rcraven » 06:00, 24 October 2016

Hi
I was wondering if any JD-800 owner could do me a favour?
I would like a sysex copy of the factory patches.

You would need to reset to the factory settings, so save your current settings first.
When that's done press DATA TRANSFER then use the cursor buttons to select FACTORY RESET and then select Yes.

You could use MidiOx to capture the Sysex file if you had a PC -
Connect the JD-800 to your PC Midi interface
View / Sysex...
On the Sysex View dialog select Sysex / Receive Manual Dump...
Give the File a name and press the SAVE button

On the JD-800 do a BULK DUMP (page IV-12 of the manual) of all the internal Midi data.
Press DATA TRANSFER and cursor to....

DATA TRANS INT->MIDI
>All Patch Setup [Y/N]

Press the INC/Yes button.

Thanks
Royce
rcraven
 
Posts: 512
Joined: 14:36, 9 September 2007
Location: Melbourne Australia


Re: JD-800 Factory Patches

Postby timbo4000 » 20:33, 9 December 2016

Hi. Did you get what you wanted here
Just Re setting up my Jd800 in my music room.
Tim
timbo4000
 
Posts: 40
Joined: 09:41, 22 October 2015

Re: JD-800 Factory Patches

Postby rcraven » 03:01, 10 December 2016

Hi Tim
I just wanted to compare the JD-800 sound to its patch data.
There are a couple of vids on YouTube with the factory sounds so I just need the patch data to compare it to.
If you could send me the factory banks patch data that would be great.

All the best
Royce
rcraven
 
Posts: 512
Joined: 14:36, 9 September 2007
Location: Melbourne Australia

Re: JD-800 Factory Patches

Postby timbo4000 » 22:51, 10 December 2016

Hi.
I have tried to send the file but its stuck in my out folder and won't send.
However I believe if you go to the following link you can download the jd800 internal syx.
Under Internal preload factory soundbank

http://bobbyblues.recup.ch/roland_jd-80 ... htm#Roland

Tim
timbo4000
 
Posts: 40
Joined: 09:41, 22 October 2015

Re: JD-800 Factory Patches

Postby rcraven » 00:11, 11 December 2016

Hi Tim,
you message got through OK.
Thanks for doing that.

All the best
Royce
rcraven
 
Posts: 512
Joined: 14:36, 9 September 2007
Location: Melbourne Australia


Return to JD, JV, XP and XV series

Who is online

Users browsing this forum: No registered users and 2 guests