XV-3080 Encoder Replacement ?

Forum for JD, JV, XP and XV synthesizers from 1990's
synthman
Posts: 111
Joined: 12:46, 10 August 2012
Location: London UK.

Re: XV-3080 Encoder Replacement ?

Post by synthman »

Thanks. Address sent via PM.
ColinD
Posts: 17
Joined: 20:31, 17 March 2017

Re: XV-3080 Encoder Replacement ?

Post by ColinD »

I've got another run of pcb's on the way for another project, so I added a few of the encoder pcb's to the board with tweaked pads that will fit the connector properly this time !! (and also a few adaptors so I can use the old boards up). So, should be now a straight swap over without bending the pins out :-)
synthman
Posts: 111
Joined: 12:46, 10 August 2012
Location: London UK.

Re: XV-3080 Encoder Replacement ?

Post by synthman »

Ok that sounds like a better idea mate :-)
synthman
Posts: 111
Joined: 12:46, 10 August 2012
Location: London UK.

Re: XV-3080 Encoder Replacement ?

Post by synthman »

Hey. Anymore news on this? Address sent to the op but no reply ?
synthman
Posts: 111
Joined: 12:46, 10 August 2012
Location: London UK.

Re: XV-3080 Encoder Replacement ?

Post by synthman »

BUMP !
ColinD
Posts: 17
Joined: 20:31, 17 March 2017

Re: XV-3080 Encoder Replacement ?

Post by ColinD »

Many apologies for going awol.... I had the newer pcb's made, but I'd already fitted the older revision into my machine by the time they arrived and so was reluctant to send out the new ones without testing them and making sure they are a good fit.... also got side tracked on another project , a change of career and other distractions.

I may get a chance to swap out the rev 1 encoder with the rev 2 tomorrow, and once confirmed working (basically a sanity check) I'll send it to you for free for your patience... I already have your address.

If any one else wants one, please email me.... colin.w.davies 'who is at ' btopenworld (dot c-o-m)

I've got enough encoders to make about 10 ? at the moment and loads of pcb's.

Thanks, Col
synthman
Posts: 111
Joined: 12:46, 10 August 2012
Location: London UK.

Re: XV-3080 Encoder Replacement ?

Post by synthman »

That's cool.thanks for the freebee. you have my addy.
vdLFO
Posts: 3
Joined: 23:28, 15 December 2018

Re: XV-3080 Encoder Replacement ?

Post by vdLFO »

ColinD make the race. ;-)

I´ve contact him to get one of the new encoders for a fair price.
NICE WORK, after a little bit soldering my XV-3080 works nice again,
hopefully for the next 20 years. :-)

Greetings from Germany
vdLFO
Post Reply