XV-3080 Encoder Replacement ?
Re: XV-3080 Encoder Replacement ?
Thanks. Address sent via PM.
Re: XV-3080 Encoder Replacement ?
I've got another run of pcb's on the way for another project, so I added a few of the encoder pcb's to the board with tweaked pads that will fit the connector properly this time !! (and also a few adaptors so I can use the old boards up). So, should be now a straight swap over without bending the pins out :-)
Re: XV-3080 Encoder Replacement ?
Ok that sounds like a better idea mate :-)
Re: XV-3080 Encoder Replacement ?
Hey. Anymore news on this? Address sent to the op but no reply ?
Re: XV-3080 Encoder Replacement ?
Many apologies for going awol.... I had the newer pcb's made, but I'd already fitted the older revision into my machine by the time they arrived and so was reluctant to send out the new ones without testing them and making sure they are a good fit.... also got side tracked on another project , a change of career and other distractions.
I may get a chance to swap out the rev 1 encoder with the rev 2 tomorrow, and once confirmed working (basically a sanity check) I'll send it to you for free for your patience... I already have your address.
If any one else wants one, please email me.... colin.w.davies 'who is at ' btopenworld (dot c-o-m)
I've got enough encoders to make about 10 ? at the moment and loads of pcb's.
Thanks, Col
I may get a chance to swap out the rev 1 encoder with the rev 2 tomorrow, and once confirmed working (basically a sanity check) I'll send it to you for free for your patience... I already have your address.
If any one else wants one, please email me.... colin.w.davies 'who is at ' btopenworld (dot c-o-m)
I've got enough encoders to make about 10 ? at the moment and loads of pcb's.
Thanks, Col
Re: XV-3080 Encoder Replacement ?
That's cool.thanks for the freebee. you have my addy.
Re: XV-3080 Encoder Replacement ?
ColinD make the race. ;-)
I´ve contact him to get one of the new encoders for a fair price.
NICE WORK, after a little bit soldering my XV-3080 works nice again,
hopefully for the next 20 years. :-)
Greetings from Germany
vdLFO
I´ve contact him to get one of the new encoders for a fair price.
NICE WORK, after a little bit soldering my XV-3080 works nice again,
hopefully for the next 20 years. :-)
Greetings from Germany
vdLFO