Hello,
It's been a while.
I'm finding difficulties with voice modulator to respond as musical digital performance data from JP8000 - Which I'm using as a midi controller.
1. I have the midi cable inserted into the Remote Keyboard In with other end jacked into midi out of JP8000.
2. I switch both devices on and execute Factory Reset. I turn devices off and on, for a refresh.
3. I toggle on Voice Mod Switch and then activate Voice Mod Lower / Upper.
4. I then select F.MT.Filter.
5. I toggle the External In button and insert a mono mic.
6. I deactivate Local in JP8000.
7. I set midi channels for the Upper / Lower in both devices - Midi data linkage.
8. I set Midi Sync on, for midi external clock (JP8080).
9. Tx / Rx Edit _ Rx Exclusive _ Tx Rx Prog - Activated in JP8080.
Now, when I INC volume on JP8080 and trigger any of the Lower / Upper keys on JP8000, there is no sound at all.
Only when I switch the Voice Mod button off, sound waves gate thru. Therefore, musical performance data is signaled, however not when Voice Mod is activated.
I have checked the mic and is working thru other outboard gear.
Either I'm making an error with parameter settings / midi connection or possibly there is a diagnostic issue with Voice Mod Generator.
I really need to get this going for a track I'm developing.
Help with this matter appreciated.
Voice Modulator midi transfer to JP8000
Re: Voice Modulator midi transfer to JP8000
Haven't been in here for a while... been busy.
Analogue modelling synth external input front / rear switch was at fault.
Took it to Roland Synth Services and Providers for service and repair.
Works very well since switch replacement and service.
Analogue modelling synth external input front / rear switch was at fault.
Took it to Roland Synth Services and Providers for service and repair.
Works very well since switch replacement and service.