Page 1 of 1

JP-8000 not sending CC data?

Posted: 16:50, 25 October 2014
by mrcabdriver
Hi all,

It's been a while since I used my JP-8000 (or any gear for that matter), and I had to replace the battery. That worked well and I recalibrated the pitchbend and ribbon with success.

However now I hooked it up to my new laptop with an ESI Midimate II (usb/midi cable) and Cubase only receives pitchbend data + note on/off data. No other CC signals are registered. The leds on the Midimate light up when I play notes and use pitchbend, but not if I use knobs or sliders.

I've also tested with MidiOx, which shows the same.

Any idea what's going on here?

Re: JP-8000 not sending CC data?

Posted: 15:18, 26 October 2014
by mrcabdriver
Just tested it the other way around, by sending controller data from Cubase to the JP-8000, it doesn't seem to receive those either.

Re: JP-8000 not sending CC data?

Posted: 15:53, 26 October 2014
by mrcabdriver
Fixed!
I set "Tx/Rx Edit SW" to "ON" and all is right in the world again. :-)