Controller questions

Forum for JUPITER-50
Post Reply
sterling17
Posts: 21
Joined: 20:20, 7 February 2016

Controller questions

Post by sterling17 »

Hello everyone,
I just brought home my new Jupiter 50 and want to assign my control pedal, which is a Boss FV500-L and a Roland sustain pedal from an Roland RD-700. I found the Control Page under System Setup and since I am using Pedal 1 input, I set the assign source to be System and set the Assign to CC07 Volume. I then played a patch and the pedal doesn't control volume. I then went back into the Controller page and changed the Polarity from Standard to Reverse and then tried it. Again it didn't work.

I'm getting the same results from the Hold Pedal. The Standard setting doesn't sustain and when i switched to Reverse, I get the same results.

Thinking that I may have to power the unit down and then back on, this may get the keyboard to see the pedals. When I did this I noticed that my settings were gone for the Controller 1 assignment and the Hold pedal.
What am I missing here?
Thx
Mark
Post Reply