I have a foot controller that transmits as source MIDI CC04. In the PCM synth engine, I can go to the MTRX CTRL tab and select foot controller for control source and filter cutoff for destination.
I can’t find an equivalent way to assign the output of foot controller (MIDI CC04) to destinations in the superNatural synth engine. Is there a way to do this?
MIDI device CC, superNatural engine parameters limitation?
-
gizzardgullet
- Posts: 2
- Joined: 17:10, 18 July 2018
Re: MIDI device CC, superNatural engine parameters limitatio
I do agree that it is a problem to have all these limitations.
I have similar issues as I am using a MIDI Wind Controller (AKAI EWI 5000 but also the AEROPHONE AE-10 from Roland) and all the Super-Natural Sound engines can hardly be used because of these limitations.
I do not have such limitation with Yamaha Synths
Roland is using exotic CC's not always available on Standard Controller or Master Keyboards (but on Roland one's)
They should update the firmware to cover these limitations
I have similar issues as I am using a MIDI Wind Controller (AKAI EWI 5000 but also the AEROPHONE AE-10 from Roland) and all the Super-Natural Sound engines can hardly be used because of these limitations.
I do not have such limitation with Yamaha Synths
Roland is using exotic CC's not always available on Standard Controller or Master Keyboards (but on Roland one's)
They should update the firmware to cover these limitations