IPad Pro 12.9in to Integra 7 connectivity issue

[Lubo_K]

IOS 15.4.1
Roland Integra 7 Editor ver. 1.1.1

Via cable USB to USB C. The cable is certified for data transmitting (not only for power)

Connected to the front UCB port of the Integra.

All settings done as recommended

Menu/system USBdriver is GENERIC(MIDI only)

In Roland Integra Editor Mode Select=Normal
device ID17 ( and can be increased to other values but the minimum possible is 17)
MIDi device : No MIDI Device

Any ideas, please?

[howardS]

You need to plug your USB cable into the port in the back of the unit, not the one in the front. The one in the front of the Integra-7 is for a memory stick or the WIFI adapter.

[Lubo_K]

Thanks

Will try just have to figure what kind of adapters for USB cable

[Lubo_K]

No difference with the back UPS, Editor still doesn’t see the Integra :-(

[Lubo_K]

Oh I finally Mede it work, thanks, with IPAD adapter and back USB. Now I have to figure out how to control the Integra if USB is occupied . Will try via DIN 5 MIDI connector

[Lubo_K]

Ok, now as it works - how do I share this back USB to be used from both DAW ( Cakewalk in my case and IPad Integra editor. When I have each one of them connected separately they work fine.
When I have Integra connected only, Cakewalk see it as Integra 7 and work fine.
When I have the the I-ad only connected the Integra editor works fine and controls the Integra box without any problems

If I put USB splitter then things get messy - the DAW sees USB device but not directly Integra 7 and dows not get sound out

Did anyone has tested solution of connecting both laptop with DAW and IPad with Editor simultaneously and they can play their music from their -ro gram but can change the instruments from IPad ?

[FGM]

Lubo_K, see theses CME products...😀😀😀😀

They promise ..."Easily configure advanced WIDI groups of up to 5 Bluetooth MIDI devices with one (1) central WIDI device and up to four (4) peripherals over 16 MIDI channels."

https://www.cme-pro.com/widi-uhost/

I know CME because I have a pair of this other product of theirs to connect my Fantom 8 and a Yamaha CVP-96 and its performance so far has been always astounding, no lag at all (announced as some 3 ms.)

https://www.cme-pro.com/widi-master/

And they are planning to develop some other products for AUDIO, not MIDI...

https://www.cme-pro.com/iwa-instant-wir ... io-by-cme/

This time promising...

Enough data rate redundancy to meet the stable transmission of high-quality uncompressed stereo audio.

No interference from crowded and noisy 2.4GHz frequency band.

Latency performance meets the demands of modern music makers.

Data transfer stability can still be guaranteed in very low voltage condition.

The cost should be acceptable to most music users.