Page 1 of 1

Roland RPU-3

Posted: 15:59, 18 February 2015
by jblongz
Can someone verify if the Roland RPU-3 (3 pedal) is fully functional with the FA series? Im considering buying for a VSTi that supports it, but I would like to know before buying. Roland's site only mentions two other digital pianos that is works with.

Re: Roland RPU-3

Posted: 00:58, 7 February 2016
by jblongz
I can verify it works

Re: Roland RPU-3

Posted: 01:41, 9 April 2016
by jblongz
I also use with Pianoteq VST. Its great.

Re: Roland RPU-3

Posted: 15:38, 18 April 2017
by BobF
Quick check before I order ... half damping works with this connected to the FA?

Re: Roland RPU-3

Posted: 22:00, 21 June 2017
by locojohn
Another question: can I use two other pedals of the RPU-3 for expression control?

Re: Roland RPU-3

Posted: 22:50, 26 June 2017
by locojohn
locojohn wrote:Another question: can I use two other pedals of the RPU-3 for expression control?
Just to answer my own question:

from the RPU-3 manual: "This product can be used by connecting it to a device that is equipped with three pedal jacks that support the use of continuous detection.".

Essentially, it means that RPU-3 can be configured to control just about any parameter, even including expression (must set up reverse polarity in the FA settings for this to work), so it's really really cool. I set up pedal 1 with "soft" message, pedal 2 with "modulation" and pedal 3 with "sustain". Everything works, halleluyah!

Andrejs

Re: Roland RPU-3

Posted: 00:36, 7 July 2019
by Victoro
Dear,
I connected the Roland RPU-3 pedal to the Roland FA08 and as said "locojohn" the parameters were changed in the system.
The RPU-3 works wonders.
Greetings to all.
Victoro