Assigning the switch 1 for rotary control

[Flavorkeys]

I am working on my FA06's rotary to be able to use in a pinch and want to change the rotary slow/ fast control from the bender to the switch 1. Maybe even d-beam. I see that now I have the source 1 showing "general-5" and source 2 showing " general-6" Does anyone know what I should change these two to get the switch controlling the rotary speed instead of the bender? Is there a CC # for the switch?

[bennyseven]

Press SHIFT and S1, then set S1 ASSIGN to CC80(General-5 ).
Also check, if your Assign settings are set to STUDIO or SYSTEM.

I found out, that if STUDIO is selected, the factory presets come with S1 assigned to SPEED and S2 assigned to BRAKE.

To apply D-Beam, press SHIFT and ASSIGNABLE (below the D-Beam sensor) and set to STUDIO or SYSTEM.

[Flavorkeys]

Thank you bennyseven that worked perfectly !!

Could you please take a look at my post today about editing the keyboard range of a sound within a studio set?

I thought what I was doing would do the trick but I must be missing something!!!