Page 1 of 1

Editing the keyboard range of a sound in a studio set

Posted: 19:29, 12 August 2017
by Flavorkeys
Help, I am trying to edit a certain lead sound in a studio set of my to not sound in the lowest octave and I have moved the cursor over to the little keyboard shown to the right of the sound and see I can edit lower range to show C#0 instead of the lowest C but the keyboard isn't shrinking to show it and the lead sound still sounds at bottom. What am I doing wrong? I gotta be missing something obvious???

Re: Editing the keyboard range of a sound in a studio set

Posted: 20:40, 12 August 2017
by CobraJet
I believe you have to turn the keyboard part on, with the little dot, then you will see the keyboard shrink to your desired size.

Re: Editing the keyboard range of a sound in a studio set

Posted: 22:29, 12 August 2017
by scramble
Yes, that sounds like it. If a part's keyboard switch is turned off then the part will still make a sound as long as that part is the currently selected part. But you can't change the range for it when it's in that state.

Re: Editing the keyboard range of a sound in a studio set

Posted: 23:49, 12 August 2017
by Flavorkeys
Yes, guys that was the trick, also you gotta spin the data wheel around a few times before it starts shrinking.
Thank you !

Re: Editing the keyboard range of a sound in a studio set

Posted: 02:29, 13 August 2017
by Gatorjohn
You can also just press the key where you want it.

Re: Editing the keyboard range of a sound in a studio set

Posted: 20:26, 13 August 2017
by bennyseven
Gatorjohn wrote:You can also just press the key where you want it.
Don't forget to hold SHIFT when pressing the key.