Page 1 of 1

V2 update, sample pad problem

Posted: 22:58, 17 August 2017
by Emmerson
Have updated to V2 firmware and connected via midi to Integra. When I use sample mode I hear a sound on the Integra when I puts a pad. The sample also plays as it used to. I think the midi code is a note on command. Can I stop this happening?

Re: V2 update, sample pad problem

Posted: 23:50, 17 August 2017
by stevel
By default, the sample pads are set to Channel 16, so yes, you probably are getting note on messages (on and off) on channel 16 triggering whatever sound is assigned to Part/Channel 16 on the Integra.

There's a new screen on the FA v. 2.0 under "Part View (within a Studio Set). Scroll over to "Master Kbd 1/2" and turn off the "PTX for Channel 16.

Conversely, you could turn off the MIDI Recieve for Part 16 on the integra (or turn the volume down on that Channel, mute it, etc. etc.

Re: V2 update, sample pad problem

Posted: 08:22, 18 August 2017
by Emmerson
Thanks, I'll try it tonight

Re: V2 update, sample pad problem

Posted: 12:45, 21 August 2017
by Emmerson
Its works fine.