Hope someone can help me .
I need to run a sequence that will trigger samples to start on my FA06 but I need the samples to be output through the Sub output only.
Is this possible to do?
If someone could help that would be great
Thanks
Sending samples to Sub output
-
- Posts: 699
- Joined: 18:01, 19 April 2014
- Location: Germany
Re: Sending samples to Sub output
yes, in PART VIEW menu go to the OUTPUT/EFX menu page and set the sample part (i.e. 16) from MAIN und to SUB. ready.
-
- Posts: 28
- Joined: 14:11, 27 February 2017
Re: Sending samples to Sub output
Many thanks I'll give that a try
-
- Posts: 28
- Joined: 14:11, 27 February 2017
Re: Sending samples to Sub output
I gave this a try but it did not route the sample to the sub output?
I have routed my click track on channel 10 to the sub output and it works just fine but the sample will not.
Is the FA limited to only 1 channel to the sub output?
Thanks in advance for any advice
I have routed my click track on channel 10 to the sub output and it works just fine but the sample will not.
Is the FA limited to only 1 channel to the sub output?
Thanks in advance for any advice