MIDI Channel off for some parts?
Posted: 14:40, 11 April 2017
Hello everybody !
I've got following Question /Problem with the MIDI Functions on the JD-XA.
In Sound Patches you can determine the receive channel for every part , but there is
no posssibilitiy to switch a Part to "MIDI off".
I often program Sounds with more Parts ..so that I can switch some parts off / on to change the Sound
on the fly while playing the keyboard.
But now the problem starts when using MIDI...
The parts that have been switched off on the Synth. will be played via MIDI.
And it seems to me that I can only change the MIDI channel of the part and
can't stop it to get played via MIDI unless I would lose an unused MIDI Channel.
But I need all 16 Channels for sequenzing.
The only "work around" that I can think of, is to change the layer of the part
on the keyboard (extreme high or low ..and only one note) ...
but this is so stupid and unflexible :-(
Do you know a solution or trick to fix this problem ?
Thank you!
Regards
Andreas (aka deep-six)
I've got following Question /Problem with the MIDI Functions on the JD-XA.
In Sound Patches you can determine the receive channel for every part , but there is
no posssibilitiy to switch a Part to "MIDI off".
I often program Sounds with more Parts ..so that I can switch some parts off / on to change the Sound
on the fly while playing the keyboard.
But now the problem starts when using MIDI...
The parts that have been switched off on the Synth. will be played via MIDI.
And it seems to me that I can only change the MIDI channel of the part and
can't stop it to get played via MIDI unless I would lose an unused MIDI Channel.
But I need all 16 Channels for sequenzing.
The only "work around" that I can think of, is to change the layer of the part
on the keyboard (extreme high or low ..and only one note) ...
but this is so stupid and unflexible :-(
Do you know a solution or trick to fix this problem ?
Thank you!
Regards
Andreas (aka deep-six)