My question:
Roland's response:I'm trying to run the JD-xi as slave to my MPC2500.
I'm simply trying to automate the chaining of JD-xi sequences.
The JD-xi starts in sync with the MPC and responds to program changes but as soon as it receives a program change the JD-xi sequencer stops running.
Can you confirm that what I'm trying to do is possible and if so what might be going wrong?
I thought I'd post this in case anyone else had been trying to do this (I naively assumed this must be possible).I have been checking this out for you but unfortunately this cannot be done.
The Patterns will stop upon a PC message.
I will put this forward as a suggestion for future firmware if possible.
Regards
Oliver Davis
Product Support Manager
Roland (UK) Ltd