Page 1 of 1

Tones are reverting to default

Posted: 22:28, 6 May 2017
by tvkorchestra
Picked this up a few weeks ago and loving it so far but I'm having an issue. I'm finding that in the digital synths when I turn the knob to select the sound category it just goes to the default sound for that category. Even on the pre-recorded programs when I turn the knob and turn it back it reverts it to the default (jd piano 1, super saw 1, seq bass 1, etc.). I'm assuming I've got to do a factory reset but before I do I wondering if I'm doing something wrong.

Any thoughts?

Re: Tones are reverting to default

Posted: 21:59, 8 May 2017
by StaccatoHeavenSC
That's just how it works. When you select a category, you'll get the first tone in that category. If you select a different tone in that category, then switch to another category, then switch back, it'll "remember" what tone you selected for that category and give it to you again, but this information isn't saved with the patch, so if you change programs or power cycle the synth it'll revert back to the 1st tone in each category when selected.

Re: Tones are reverting to default

Posted: 04:13, 10 May 2017
by tvkorchestra
well...that's stupid...