JP-08 external CC control patch saving problem

Forum for boutique synths
Post Reply
nywknh
Posts: 1
Joined: 14:15, 10 May 2017

JP-08 external CC control patch saving problem

Post by nywknh »

Hello,
I was experimenting with CC and JP-08 and found out that only certain parameters are saved while saving a patch. For example if I change delay feedback with external controller with CC and then save a patch, the data is stored correctly, however if i change filter cutoff from external contoller and then save a patch it gets back to initial VCF value stored previously in a patch .
I have checked the output of online editor (https://data.dynareg.se/breadandbutter/JP08.html) with MIDI Monitor, and it is sending sysex which is saved correctly with no problem for all parameters (saving on the actual synth by pressing and holding is ment).
Is saving after editing with external CC not supported by current software of the synth?
Is there a sysex command list for JP-08 somewhere?

Thanks
Post Reply