I just stumbled on the new firmware update may 2017 ver 1.2. It adds a new control mode. Typically Roland well that's all it says and refers to the new manual. And yep you guessed it. The manual says nothing about it. Has anybody loaded it? What's it do?
You know what .... the sooner that behringer starts kicking roland's a*s the better.
new firmware for ju06
Re: new firmware for ju06
Did you scroll down the page to see a link to the 1.20 Supplementary Manual? Perhaps not.
Here is the text contained in that document for you;
This document explains the functions that have been added to the JU-06. Read it in conjunction with the owner’s manual.
Controlling the JUNO-106 Software Synthesizer
You can use the controllers of the JU-06 to control the JUNO-106 software synthesizer inside your DAW software. MEMO For details on the JUNO-106 software synthesizer, refer to Roland Cloud (https://www.rolandcloud.com/).
1. Using a USB cable, connect the JU-06 to your computer.
2. While holding down the PATCH NUMBER [8] button, turn on the power. You’ll need to install a USB driver on the computer. For details, refer to the JU-06 owner’s manual. The JU-06 is in software synthesizer control mode, and the display indicates “Ct”.
3. As the MIDI input device in the DAW software you’re using, choose “Boutique.” For more about the settings of your DAW software, refer to your DAW’s help or owner’s manual.
* If you select control mode, the internal sound engine does not play. * If you select control mode, the following settings change. 5 MIDI CH: 1 ch 5 Control change output mode: Output to both USB and MIDI.
MEMO
To return to normal mode, turn the power off and on again.
Here is the text contained in that document for you;
This document explains the functions that have been added to the JU-06. Read it in conjunction with the owner’s manual.
Controlling the JUNO-106 Software Synthesizer
You can use the controllers of the JU-06 to control the JUNO-106 software synthesizer inside your DAW software. MEMO For details on the JUNO-106 software synthesizer, refer to Roland Cloud (https://www.rolandcloud.com/).
1. Using a USB cable, connect the JU-06 to your computer.
2. While holding down the PATCH NUMBER [8] button, turn on the power. You’ll need to install a USB driver on the computer. For details, refer to the JU-06 owner’s manual. The JU-06 is in software synthesizer control mode, and the display indicates “Ct”.
3. As the MIDI input device in the DAW software you’re using, choose “Boutique.” For more about the settings of your DAW software, refer to your DAW’s help or owner’s manual.
* If you select control mode, the internal sound engine does not play. * If you select control mode, the following settings change. 5 MIDI CH: 1 ch 5 Control change output mode: Output to both USB and MIDI.
MEMO
To return to normal mode, turn the power off and on again.
Re: new firmware for ju06
PS It'll take a lot more than Behringer to do that...
- cloudburst
- Posts: 181
- Joined: 20:00, 11 November 2015
- Location: Northern Ireland
- Contact:
Re: new firmware for ju06
To the OP - although you didn't intend it, it's misleading to post a new thread titled "new firmware for JU-06" referring to an update that's a few months old.
This will cause numerous of us to scurry off in search of something which isn't there.
Please note that this thread was posted at the time:
viewtopic.php?f=59&t=53611
CB
This will cause numerous of us to scurry off in search of something which isn't there.
Please note that this thread was posted at the time:
viewtopic.php?f=59&t=53611
CB