Basic question: Change modulation speed?

Forum for Juno-DS and XPS-30 keyboards

Basic question: Change modulation speed?

Postby AaronPDX1 » 20:57, 20 November 2017

Where does one find the values to adjust to change modulation speed and range (using lever or control pedal) ?

Thanks.
AaronPDX1
 
Posts: 55
Joined: 17:58, 8 May 2017


Re: Basic question: Change modulation speed?

Postby joelfan » 13:46, 23 November 2017

Page 11 of JUNO-DS ParamGuide, Aaron.
joelfan
 
Posts: 41
Joined: 12:54, 4 April 2013

Re: Basic question: Change modulation speed?

Postby AaronPDX1 » 21:34, 28 November 2017

Thanks Joelfan!

And here's a little more info from Roland:

The Modulation settings are controlled in the "Matrix Control" section of the Tone Edit menu. Press MENU, select, "Edit", then seledt "Patch Edit" then cursor to the "MTRX CTRL 1-4" tabs. This is where are modulation control is handled for the Patch and you can select a Source (such as Modulation), a Destination (such as Pitch) and an amount. This is used to set up any modulation and also the amount used.

The speed is usually the LFO speed, so you need to cursor to the LFO1 or LFO2 tab to set this.

You can see information on the LFO settings on page 11 of the Juno-DS Parameter Guide, and information on the Matrix Control tabs on page 13.
AaronPDX1
 
Posts: 55
Joined: 17:58, 8 May 2017


Return to Juno-DS / XPS-30

Who is online

Users browsing this forum: No registered users and 1 guest