Cutoff knob impacting multiple parts in performance

Forum for Juno-DS and XPS-30 keyboards
Post Reply
Bomi
Posts: 17
Joined: 22:32, 17 January 2017
Location: Winterthur
Contact:

Cutoff knob impacting multiple parts in performance

Post by Bomi »

dear all,

when using a performance with multiple parts at the same time (layered), is it possible to configure that when turning the knob steering the cutoff to steer not only the (via pad) selected part but also the other layered ones?

I wanna layer some synths and apply the cutoff to all of the layers, not just the active one...

thx

Beat
snip_20170222205842.png
snip_20170222205842.png (207.91 KiB) Viewed 1657 times
snip_20170222210111.png
snip_20170222210111.png (130.17 KiB) Viewed 1657 times
anotherscott
Posts: 513
Joined: 19:05, 1 July 2010

Re: Cutoff knob impacting multiple parts in performance

Post by anotherscott »

I think it controls only one part of a Performance, unless you're using dual (or super layer) in which case it will affect it all together.
frieker
Posts: 13
Joined: 09:29, 4 January 2019

Re: Cutoff knob impacting multiple parts in performance

Post by frieker »

If you use a Expression Pedal and Choos CUT Off for it. Its Works
Leokuma
Posts: 27
Joined: 14:22, 10 July 2018
Location: São Paulo, Brazil

Re: Cutoff knob impacting multiple parts in performance

Post by Leokuma »

frieker wrote:If you use an Expression Pedal and choose CUT for it, it works.
It also works with the mod wheel, and you can choose which Parts will be affected. You need to configure a Matrix Control with the mod wheel (SYS-CTRL1) as source and CUT as destination in every Part you want to be affected.
Post Reply