Roland Clan Forums

dear all,

when using a performance with multiple parts at the same time (layered), is it possible to configure that when turning the knob steering the cutoff to steer not only the (via pad) selected part but also the other layered ones?

I wanna layer some synths and apply the cutoff to all of the layers, not just the active one...

thx

Beat

I think it controls only one part of a Performance, unless you're using dual (or super layer) in which case it will affect it all together.

If you use a Expression Pedal and Choos CUT Off for it. Its Works

frieker wrote:If you use an Expression Pedal and choose CUT for it, it works.

It also works with the mod wheel, and you can choose which Parts will be affected. You need to configure a Matrix Control with the mod wheel (SYS-CTRL1) as source and CUT as destination in every Part you want to be affected.