Basic question: Change modulation speed?

Forum for Juno-DS and XPS-30 keyboards
Post Reply
AaronPDX1
Posts: 162
Joined: 17:58, 8 May 2017

Basic question: Change modulation speed?

Post by AaronPDX1 »

Where does one find the values to adjust to change modulation speed and range (using lever or control pedal) ?

Thanks.
joelfan
Posts: 76
Joined: 12:54, 4 April 2013

Re: Basic question: Change modulation speed?

Post by joelfan »

Page 11 of JUNO-DS ParamGuide, Aaron.
AaronPDX1
Posts: 162
Joined: 17:58, 8 May 2017

Re: Basic question: Change modulation speed?

Post by AaronPDX1 »

Thanks Joelfan!

And here's a little more info from Roland:

The Modulation settings are controlled in the "Matrix Control" section of the Tone Edit menu. Press MENU, select, "Edit", then seledt "Patch Edit" then cursor to the "MTRX CTRL 1-4" tabs. This is where are modulation control is handled for the Patch and you can select a Source (such as Modulation), a Destination (such as Pitch) and an amount. This is used to set up any modulation and also the amount used.

The speed is usually the LFO speed, so you need to cursor to the LFO1 or LFO2 tab to set this.

You can see information on the LFO settings on page 11 of the Juno-DS Parameter Guide, and information on the Matrix Control tabs on page 13.
Post Reply