Page 1 of 1

Basic question: Change modulation speed?

Posted: 20:57, 20 November 2017
by AaronPDX1
Where does one find the values to adjust to change modulation speed and range (using lever or control pedal) ?

Thanks.

Re: Basic question: Change modulation speed?

Posted: 13:46, 23 November 2017
by joelfan
Page 11 of JUNO-DS ParamGuide, Aaron.

Re: Basic question: Change modulation speed?

Posted: 21:34, 28 November 2017
by AaronPDX1
Thanks Joelfan!

And here's a little more info from Roland:

The Modulation settings are controlled in the "Matrix Control" section of the Tone Edit menu. Press MENU, select, "Edit", then seledt "Patch Edit" then cursor to the "MTRX CTRL 1-4" tabs. This is where are modulation control is handled for the Patch and you can select a Source (such as Modulation), a Destination (such as Pitch) and an amount. This is used to set up any modulation and also the amount used.

The speed is usually the LFO speed, so you need to cursor to the LFO1 or LFO2 tab to set this.

You can see information on the LFO settings on page 11 of the Juno-DS Parameter Guide, and information on the Matrix Control tabs on page 13.