RD2000 - Pedal setup for B3 program

Stage Pianos
Post Reply
darrylhebert
Posts: 2
Joined: 17:19, 5 October 2017

RD2000 - Pedal setup for B3 program

Post by darrylhebert »

Is there a way to set the sustain pedal to act as rotor on/off?
DesertBoat
Posts: 362
Joined: 01:49, 5 October 2017

Re: RD2000 - Pedal setup for B3 program

Post by DesertBoat »

There does not appear to be any assignment for sustain in the Program Edit / Pedal Assign menu. The only adjustment to sustain is the ability to tell a zone not to respond to sustain. (Zone edit / Pedal menu page)

The other three pedal inputs are fully assignable.

Another foot switch is cheap enough, or if an organist who doesn't need sustain, just swap the sustain to one of the other three pedal inputs.
darrylhebert
Posts: 2
Joined: 17:19, 5 October 2017

Re: RD2000 - Pedal setup for B3 program

Post by darrylhebert »

Thanks for the reply.

I currently use 3 pedals with the RD2000 - sustain, FC1 - rotor on/off, FC2 - program change up.

I was hoping to eliminate a pedal...oh well...
Post Reply