RD2000 - Pedal setup for B3 program
-
- Posts: 2
- Joined: 17:19, 5 October 2017
RD2000 - Pedal setup for B3 program
Is there a way to set the sustain pedal to act as rotor on/off?
-
- Posts: 362
- Joined: 01:49, 5 October 2017
Re: RD2000 - Pedal setup for B3 program
There does not appear to be any assignment for sustain in the Program Edit / Pedal Assign menu. The only adjustment to sustain is the ability to tell a zone not to respond to sustain. (Zone edit / Pedal menu page)
The other three pedal inputs are fully assignable.
Another foot switch is cheap enough, or if an organist who doesn't need sustain, just swap the sustain to one of the other three pedal inputs.
The other three pedal inputs are fully assignable.
Another foot switch is cheap enough, or if an organist who doesn't need sustain, just swap the sustain to one of the other three pedal inputs.
-
- Posts: 2
- Joined: 17:19, 5 October 2017
Re: RD2000 - Pedal setup for B3 program
Thanks for the reply.
I currently use 3 pedals with the RD2000 - sustain, FC1 - rotor on/off, FC2 - program change up.
I was hoping to eliminate a pedal...oh well...
I currently use 3 pedals with the RD2000 - sustain, FC1 - rotor on/off, FC2 - program change up.
I was hoping to eliminate a pedal...oh well...