Roland Clan Forums

Is there a way to set the sustain pedal to act as rotor on/off?

There does not appear to be any assignment for sustain in the Program Edit / Pedal Assign menu. The only adjustment to sustain is the ability to tell a zone not to respond to sustain. (Zone edit / Pedal menu page)

The other three pedal inputs are fully assignable.

Another foot switch is cheap enough, or if an organist who doesn't need sustain, just swap the sustain to one of the other three pedal inputs.

Thanks for the reply.

I currently use 3 pedals with the RD2000 - sustain, FC1 - rotor on/off, FC2 - program change up.

I was hoping to eliminate a pedal...oh well...