There are settings on the Jupiter X-Xm that are individually controlled in each Scene instead of being the expected System (global) setting. This provides flexibility, but also becomes a pain to make a bulk change. This layout has a single function - bulk edit these settings as if they were a System setting. This layout is separate from the other Jupiter X-Xm layouts as it should be infrequently required
https://mididesigner.com/qa/
Jupiter X-Xm Global Settings layout for MDP2
-
- Posts: 362
- Joined: 01:49, 5 October 2017
-
- Posts: 362
- Joined: 01:49, 5 October 2017
Re: Jupiter X-Xm Global Settings layout for MDP2
This file will set parts 1-5 to midi receive channels 4-8. Need a sysex librarian to load into the Jupe.
Remove the .txt file type before using, file type is .syx.
Slow down the librarian transmit speed so the Jupe doesn't choke. A scene or two might get skipped, so also helps to run 2 or 3 times. The data is all there, just might skip a reception.
Also, good practice to ALWAYS back up before running something that sends data to the non-temporary locations. This has been throughly tested, but always helps to be careful.
Remove the .txt file type before using, file type is .syx.
Slow down the librarian transmit speed so the Jupe doesn't choke. A scene or two might get skipped, so also helps to run 2 or 3 times. The data is all there, just might skip a reception.
Also, good practice to ALWAYS back up before running something that sends data to the non-temporary locations. This has been throughly tested, but always helps to be careful.
- Attachments
-
- Set Parts 1-5 Channels 4-8.syx.txt
- (18.75 KiB) Downloaded 119 times