Control Pedal to Morph between Two Sounds

Forum for Fantom-S/S88, Fantom-X6/7/8, Fantom-XR and Fantom-Xa
Post Reply
User avatar
Andy Keys
Posts: 1843
Joined: 13:44, 7 August 2007
Location: UK

Control Pedal to Morph between Two Sounds

Post by Andy Keys »

Hi all,
I'm trying to work out a way to set up the Control Pedal to morph between two sounds.

I've got a Patch programmed where Tones 1 & 2 make up sound A and tones 3 & 4 make up sound B.

On the Alesis QSR I would set the control pedal to control Volume cc07 (or Expression cc11) and set Tones 1&2 to 0, modulating to 127, and then 3&4 to 127 modulating to 0.

I'm sure it's as straight forward on the Fantom, but I can't work it out.
Has anyone done this already? Any help gratefully received!

Cheers,
Andy
User avatar
piaknowguy
Posts: 2071
Joined: 22:29, 14 April 2004
Location: Canada
Contact:

Re: Control Pedal to Morph between Two Sounds

Post by piaknowguy »

Hey Andy!

I"m not near the board right now but I have done this between 2 patches before.
I would copy tones 1 and 2 to 1 USER patch and tones 3 and 4 to a second USER patch and go from there.

Cheers!
rcraven
Posts: 629
Joined: 14:36, 9 September 2007
Location: Melbourne Australia

Re: Control Pedal to Morph between Two Sounds

Post by rcraven »

Hi Andy,
Adding to piaknowguy, go to the Matrix Control and set an input to an unused CC.
Destination is LEVEL, Tone 1&2 are ON and Tone 3&4 are REV and adjust SENS to full (or -ve full if it xfades the wrong way).
Menu button - Pedal/DBeam set the Continuous Pedal to the above CC.

All the best
Royce
Post Reply