I bought my first Juno Stage yesterday and found a problem. I have two sustain pedals with different polarities, so I tried both of them (insert into Hold, right?). After I disconnected the pedals, the keyboard continued to sustain for a while. Sometimes it stopped and then it was beginning to sustain again (with pedals disconnected).
Is this some kind of a short reaction of the keyboard to the pedals with different polarities or is this a more serious problem?
Thank you
Sustain problem with Juno Stage
-
- Posts: 20
- Joined: 06:04, 23 January 2017
Re: Sustain problem with Juno Stage
It is probably a quirk in the Juno Stage. That board had some weird issues throughout it's run. There is probably steps you can take to make it the same every time.
Re: Sustain problem with Juno Stage
I had that issue, I fixed it by doing one of the following (I actually did all three but don't know which one actually fixed it, just glad it did!):
Turn off continuous switch on pedal (if equipped)
Restore Juno to factory, then restored my backup
Used a Roland brand pedal
Works ever since. Good luck!
Turn off continuous switch on pedal (if equipped)
Restore Juno to factory, then restored my backup
Used a Roland brand pedal
Works ever since. Good luck!