Ribbon defect on new SH-01A??
-
- Posts: 2
- Joined: 17:43, 29 January 2018
Ribbon defect on new SH-01A??
Is this normal behaviour, the ribbon slider to the right doesn´t light up until it´s touched aprx 2 cm from the top? Nothing happens til I reach the top, the ribbon for the pitchbend works as it should.
- Attachments
-
- VID_20180129_181459.mp4
- (12.7 MiB) Downloaded 717 times
- cloudburst
- Posts: 181
- Joined: 20:00, 11 November 2015
- Location: Northern Ireland
- Contact:
Re: Ribbon defect on new SH-01A??
Just checked the C2 ribbon on my SH-01A for you.
Mine activates very close to the bottom and works all the way to the top.
The boutique ribbon controllers can be a bit temperamental at the best of times, but yours sounds like a defect. When buying my VP-03, I had to send the first one back as there was a little bump under the C1 ribbon; the replacement unit was fine.
CB
Mine activates very close to the bottom and works all the way to the top.
The boutique ribbon controllers can be a bit temperamental at the best of times, but yours sounds like a defect. When buying my VP-03, I had to send the first one back as there was a little bump under the C1 ribbon; the replacement unit was fine.
CB
-
- Posts: 2
- Joined: 17:43, 29 January 2018
Re: Ribbon defect on new SH-01A??
Thanks for checking. Found youtube-videos showing the riobbon working all the way so I got my unit replaced this morning in the store where I bought it. Seemed like a case of doa...
Cheers.
Cheers.