Roland Clan Forums

Hello,

I have a Roland Juno GI and i want to send SysEx to change the transpose values.
If i look in the Juno GI manual i can see the parameters.
I can't figure out how to read the parameters.
Is somebody out there who can help me with the right SysEx?

Thanks.

Is there nobody who can help me?
Please.

The sysex message consists of:

Header:
f0 41 10 00 00 4c 12

Address:
01 00 00 37

Value: 0x40 is C->C (Values may vary from 59 -> 70 or 0x3b to 0x46)
40

Checksum:
Refer to the manual. For the example where value = 0x40, the checksum is 0x08
08

Footer:
f7

So the whole message should look like:
f0 41 10 00 00 4c 12 01 00 00 37 40 08 f7

If you can't be bothered calculating the checksum, here are all the possibilities:
f0 41 10 00 00 4c 12 01 00 00 37 3b 0d f7 (C -> G)
f0 41 10 00 00 4c 12 01 00 00 37 3c 0c f7 (C -> G#)
f0 41 10 00 00 4c 12 01 00 00 37 3d 0b f7 (C -> A)
f0 41 10 00 00 4c 12 01 00 00 37 3e 0a f7 (C -> Bb)
f0 41 10 00 00 4c 12 01 00 00 37 3f 09 f7 (C -> B)
f0 41 10 00 00 4c 12 01 00 00 37 40 08 f7 (C -> C)
f0 41 10 00 00 4c 12 01 00 00 37 41 07 f7 (C -> C#)
f0 41 10 00 00 4c 12 01 00 00 37 42 06 f7 (C -> D)
f0 41 10 00 00 4c 12 01 00 00 37 43 05 f7 (C -> Eb)
f0 41 10 00 00 4c 12 01 00 00 37 44 04 f7 (C -> E)
f0 41 10 00 00 4c 12 01 00 00 37 45 03 f7 (C -> F)
f0 41 10 00 00 4c 12 01 00 00 37 46 02 f7 (C -> F#)